Installation manual

Chapter 5: Configuring the CopperJet
This pag
• Set the subnet for the D the same subnet used on the
IP interface by selecting Ethernet-0.
client that requests the lease, does not ask for a
specific expiry time (43200) the default time (in seconds)
subnet assigns to a
ase does not ask for a
253 addresses by
rver address OR
• t Gateway address.
nce yo s for your DHCP server, click on OK.
elete
is allows you to edit all
e allows you to:
HCP Server manually OR use
Default lease time: If the
will be assigned to a lease.
Max lease time: The maximum time (in seconds) that a
lease if the client requesting the le
specific expiry time (86400).
• Set the DHCP address range manually OR use a default range of
selecting Use Default Range.
• Set your CopperJet to give out its own IP address as the DNS Se
manually set the primary and secondary DNS Server addresses. When Use Router
as DNS Server is selected, DNS Relay will be enabled.
Set your CopperJet to give out its own IP address as the defaul
In most situations this is enabled.
u have entered new configuration detail
O
You will return to the DHCP Server page. The DHCP Server subnet is now added. To d
the DHCP Server subnet mark the box Delete? and click on Apply.
or advanced options click on the Advanced Options… hyperlink. Th
F
of the values that were set when the subnet was created. At the bottom of the page, click
on the Create new DHCP option link. The Create DHCP server configuration option page is
displayed:
Page 48