Installation manual

Chapter 5: Configuring the CopperJet
5.11 DHCP Server
DHCP allows you to dynamically assign IP address to the computers connected to the
Ethernet of the CopperJet. The CopperJet allows multiple DHCP Servers for multiple IP
subnets. Usually, you would only require 1 DHCP Server.
5.11.1 Configuring DHCP Server
To enable the DHCP Server, go to the Configuration menu and select DHCP server.
The DHCP Server page is displayed.
Click on the Enable button.
By Add new interface, select the interface that you want to use and click on Add.
Ethernet-0 is only available at the moment!
After you have enabled the DHCP Server (by clicking on the Enable button), you need to
define a DHCP Server subnet(s).
Click on Create new Subnet….
The Create new DHCP server subnet page is displayed.
Page 47