Installation manual

Chapter 5: Configuring the CopperJet
5.10 IP Routes
This option allows you to create static IP routes to destination addresses
via an IP interface name or a Gateway address. From the Configuration
menu, click on IP routes. The Edit Routes page is displayed:
his page lists the following information about existing routes:
• Whether the route is valid
T
or invalid
• Destination IP address
• Gateway address
• Netmask address
o edit the destination, gateway and netmask address of a route, click in the relevant
o edit the cost and interface setting for the route, click on the Advanced Options
o delete an existing route, check the Delete? box for a specific route and click on Apply.
5.10.1 Creating an IP V4 Route
To create an IP V4 Route click on Create new IP V4 Route.
omplete the Create IP v4 Route form in order to configure the route.
hen you have typed the details, click on OK. The Edit Routes page is displayed.
T
text box, update the information then click on Apply.
T
hyperlink for a specific route and update the relevant information. Click on OK.
T
The Create new IP V4 Route page is displayed:
C
W
The table now contains details of the route that you have just created.
Page 46