Installation manual

Chapter 5: Configuring the CopperJet
5.8 Search Service
The Search Service menu allows you to set auto-provisioning to scan a fixed list of PVCs
for protocols such as RFC 1483, PPPoA and PPPoE. It automatically creates a suitable
transport and attaches it to the IP Stack.
From the Configuration menu, click on Search service. The Edit Scan PVC page is
displayed.
Click on the Value drop-down list and click on true. Click on the Apply button. The scan
starts, and the Options on this page are updated with the status of the scan:
• Percent Complete: displays scan progress (as a percentage)
• Showtime Polls: number of times that DSL showtime is checked
• Max PVCs: maximum number of PVCs that the scan should look up
• Found PVCs: Number of PVCs found by the scan
• Scan State:
idle (not scanning)
waitingForResponse (currently scanning)
waitingForShowtime (currently polling DSL showtime)
Aborted (the scan was stopped before scanning was complete)
FoundPVC (scanning is complete - at least one PVC found)
noPVCsFound (scanning is complete - scan failed to detect any PVCs)
• Version: version number of the scan module
Page 41