Installation manual

Chapter 5: Configuring the CopperJet
secondary session to be initiated only to/from the same
remote host. Default allow.
Max Activity Interval: Type the maximum interval time (in milliseconds) between
the use of secondary port sessions. Default 10000.
Enable Session Chaining: Select Allow or Block depending on whether you want to
allow multi-level TCP session chaining. Default allow.
Enable UDP Session Chaining: Select Allow or Block depending on whether you want to
allow multi-level UDP and TCP session chaining. You must
set Enable Session Chaining to Allow if you want this to
work. Default allow.
Binary Address Replacement: Select Allow or Block depending on whether you want to
use binary address replacement on an existing trigger.
Default allow.
Address Translation Type: Specify what type of address replacement is set on a
trigger. You must set Binary Address Replacement to Allow
if you want this to work. Default none.
When finished configuring the Trigger, click on Apply. The Firewall Trigger Configuration
page is displayed, containing details of the trigger that you have just configured.
5.7.8.3 Deleting Triggers
Each trigger displayed in the Firewall Trigger Configuration page has a Delete hyperlink
assigned to it. To delete a trigger, click on this link. The confirmation page is displayed.
Click on the Delete button to delete the Trigger.
The Firewall Trigger Configuration page is displayed and details of the deleted trigger have
been removed.
Page 40