Installation manual

Chapter 5: Configuring the CopperJet
For a TCP portfilter click on Add TCP Filter.
The Firewall Add TCP Port Filter page is displayed:
omplete the source/destination addresses, and the source/destination port range for the
or a non-TCP/UDP portfilter (Raw IP Filter) click on Add Raw IP Filter. The Firewall Add
pecify the source/destination addresses and the IP protocol number in the relevant text
oxes. For example, for IGMP, enter protocol number 2.
he Firewall Portfilters page is
link assigned to
. To delete a portfilter, click on this link, then at the confirmation page, click on the
C
protocol (TCP or UDP selected from the protocol drop-down list) that you want to filter.
Use the Direction drop-down lists to specify whether you want to allow/block inbound
traffic, and allow/block outbound traffic. Click Apply. The Firewall Port Filters page is
displayed, containing details of the TCP/UDP port filter that you have just added.
F
Raw IP Filter page is displayed:
S
b
Then use the Direction drop-down lists to specify whether you want to allow/block inbound
traffic, and allow/block outbound traffic. Click on Apply. T
displayed, containing details of the IP port filter that you have just added.
Each portfilter displayed in the Firewall Port Filters page has a Delete hyper
it
Delete button. The portfilter is removed from the Firewall configuration.
Page 37