Installation manual

Chapter 5: Configuring the CopperJet
5.7 Security
The CopperJet has extensive Security functionality like a Stateful Inspection Firewall,
Network Address Translation (NAT) and Filters. One of the most used functionality is NAT.
Security allows you to:
• Enable Security
• Enable Firewall
• Enable Intrusion Detection
• Configure Security level
• Configure Security interfaces
• Configure Firewall Policy
• Configure Firewall Trigger
• Configure Intrusion Detection
NAT allows you to:
• Enable NAT between interfaces
• Configure global addresses
• Configure reserved mapping
Go to the Configuration menu and select Security. The Security Interface Configuration
page is displayed.
This page contains the default Security settings. Before the security options can be
configured, interfaces need to be defined to which the security can be assigned to.
5.7.1 Enabling Security
You must enable Security before you can add security functionality like Firewall, NAT or
filters.
In the Security State section:
Click on the Security Enabled radio button and select Change State to update the Security
State section. The overall Security is now enabled.
Page 31