Installation manual

Chapter 5: Configuring the CopperJet
Password: Fill in the password provided by your service provider.
Password (confirm): Fill in the password provided by your service provider.
Keep Alive: On by default. Some ISP’s time-out if the connection has
not been used. To avoid it, you can enable keep-alive that
keeps the connection by accessing an Internet site at
regular intervals.
Connect on demand: Off by default. When enabled, the PPP link will be
established when traffic is sent to the Service Provider and
disconnected when traffic has stopped for a certain amount
of time. See also the Maximum Idle Time.
Maximum idle time: 0 by default. When Connect On demand is enabled, this
time represents the idle time when the PPP link will be
disconnected.
Requested WAN IP address: Fill in 0.0.0.0 when you get an IP address after
authentication, or fill in a fixed IP address provided by your
service provider.
Enable NAT: NAT is by default enabled.
When you are finished with configuring the WAN connection, click on OK. Go to the
Configuration menu and click on Save config to save the new settings into the CopperJet.
Page 28