Installation manual

Chapter 5: Configuring the CopperJet
5.6 WAN Connections
To create a DSL Connection, you need to add a WAN connection. Depending on the
network of your ISP, you need to configure either a BRIDGED or ROUTED WAN connection.
Bridged connections are often RFC1483 BRIDGED (attached to the Bridge). Routed
connections are often RFC1483 ROUTED, PPPoE, PPPoA or IPoA (attached to the Router).
The most commonly used WAN connections are described in section
6 WAN Configuration
Examples
.
To create and configure WAN connections for your CopperJet, go to the Configuration
menu and click on WAN connections. The WAN connections page is displayed.
This page contains a table that displays the current WAN connections or services that have
been created. To create a new WAN connection, click on Create a new service. The New
WAN Service page is displayed.
This page contains a list of all the WAN connections that are available. Select the type of
service you wish to create and click on Configure.
Page 21