Installation manual

Chapter 5: Configuring the CopperJet
This page contains the Default LAN Port table that allows you to configure the following:
IP Address: Configure the Primary (default) IP address and subnet
mask for the IP interface.
Virtual IP interface: Create or edit a Virtual IP interface.
For more advanced options of the IP interface, click on the Advanced Configuration…
hyperlink.
Once you have configured your IP addresses, click on the OK button. A message is
displayed confirming that your address information is being updated. You may need to
enter the new IP address in your web browser address box.
5.5.1.1 Virtual Interface
A virtual Interface can be used to assign a multiple IP address to the CopperJet (Multi
homing). The IP address of the Virtual Interface MUST be in a different subnet than the
Default LAN IP address.
To add a Virtual IP interface click on the Create new Virtual IP Interface… hyperlink.
The Create virtual interface page is displayed.
Fill in IP address and Netmask. This should be in a different subnet as the Default Ethernet
IP interface address. Once you have configured your Virtual IP address and Netmask, click
on Apply. You will return to the LAN connections page. The virtual interfaces section
contains a table listing the names of the virtual interface(s). Each virtual interface is called
item# by default.
Each virtual interface name has an Edit and a Delete link associated with it.
To edit a service:
a Click Edit.
b Change the options for the existing virtual interface, then click Apply.
The page is reset and the new values are displayed.
To delete a service:
a Click Delete.
b Click on Delete this connection.
When finished configuring, go to the Configuration menu and click on Save config to save
the new settings into the CopperJet.
Note: Make sure, after you have changed the LAN IP addresses, that your network card is
in the same subnet as your new CopperJet LAN IP address.
Page 20