Installation manual

Chapter 5: Configuring the CopperJet
5.5 LAN Connections
LAN Connections allows you to configure the Ethernet connection. The Ethernet connection
CANNOT be removed only edited.
Go to the Configuration menu and click on LAN connections. The LAN Connections page is
displayed.
This page displays a table that lists all existing LAN connections. This table contains the
following information:
Service Name: Name of the LAN port
IP/Bridge Interface: Internal name of the LAN port.
Description: Description of the connection.
Creator: Which management entity the service was created in; CLI,
Firmware, WebAdmin or Vendor (Factory Defaults).
5.5.1 Edit a LAN connection
To update or edit your LAN IP address, click on the Edit hyperlink of the LAN connection
you want to update or edit. The Default LAN Port page is displayed.
Page 19