Installation manual

Chapter 5: Configuring the CopperJet
5.2 Quickstart
With the Quickstart option you can configure your CopperJet in only a few steps. The
number of steps is depending on the specific ISP network.
To use the Quickstart, click on Quickstart (on the left hand side).
The Quickstart page is displayed.
Select your ISP network from the dropdown-list and click on Next>. Some settings may
already been pre-configured. This is shown at the top of the page Pre-defined Settings.
Depending on the selected network, you may have to enter more information like fill in
Username and Password.
If you are finished entering all the information, click on Next> and the Store Configuration
& Restart Device page is displayed.
Click on Store.
The configuration will now be saved into the device and will reboot.
After reboot the CopperJet is correctly configured for your ISP network.
Note: Depending on the pre-defined settings, your network card settings may not be
correct anymore. Make sure that your network card is correctly configured.
Page 12