Installation manual

Chapter 5: Configuring the CopperJet
5 Configuring the CopperJet
Configuration of the CopperJet ADSL router can be done through the build-in HTTP
WebServer. Users can access this WebServer using a standard browser like Netscape
Navigator or Microsoft Internet Explorer.
5.1 Accessing the build-in WebServer
To access the build-in WebServer, you need to launch a HTTP Web browser. Enter the IP
address of the CopperJet in the address bar.
The default Ethernet IP address of the CopperJet is: 172.19.3.1
The default USB IP address of the CopperJet is: 172.20.3.1
The address for accessing the CopperJet’s WebServer through an Ethernet connection
would be
HTTP://172.19.3.1/ and for the USB connection would be HTTP://172.20.3.1/ .
Note: To access the WebServer you need to have an IP address on your network card that
is in the same subnet as the CopperJet (Example:172.19.3.2 subnet mask
255.255.0.0). By default the DHCP Server of the CopperJet is enabled, so an IP
address will be provided automatically from the CopperJet on the network card.
You will be asked for a Username and Password. Enter your username and password to
access the pages. The default network login is:
Username: admin
Password: admin
Click on OK. You can now configure your CopperJet using the WebServer.
The first time that the WebServer is launched during a session, the Welcome! message is
displayed at the top of the Status homepage. This message is replaced by the Status
heading once the page is automatically or manually refreshed.
Page 11