Installation manual

Chapter 2: LED Indicators and back panel
Page 6
2.3 CopperJet 82x LED indicators
Power: When the CopperJet is connected to a power source, the Power LED
will illuminate.
ADSL: Blinking indicates that the DSL protocols starts handshaking.
Illuminates when the ADSL network is correctly configured and
connected.
USB: The USB led will illuminate when you connect the CopperJet to the
USB port on your PC, and the USB drivers are installed. Note: not
available on all units.
Ethernet: The Ethernet led will illuminate when you connect the CopperJet to
the Ethernetport on the PC or hub/switch.
2.4 CopperJet 82x back panel
PWR: Only the power adapter that comes with the package can be
connected to the power jack.
LINE: To connect the CopperJet to the ADSL line of your provider.
USB: To connect the CopperJet to the USB port of the PC. Note: not
available on all units.
Ethernet: To connect the CopperJet to the Ethernet port of the PC, hub or
switch.
2.5 Softkey
The purpose of the Softkey is to return the CopperJet to its factory default
settings. When pressing and holding the button, the lights will start to blink
indicating that the default configuration is about to be restored. When keeping
the button pressed, the lights will stop blinking and stay on indicating that the