Installation manual

Chapter 2: LED Indicators and back panel
Page 5
2 LED Indicators and back panel
Before you begin with the installation, please take a moment to become more
familiar with the LED indicators and back panel of the CopperJet.
2.1 CopperJet 81x LED indicators
ACT: Blinks when data traffic is generated.
ADSL: Blinking indicates that the DSL protocols starts
handshaking. Illuminates when the ADSL network is
correctly configured and connected.
ETH: The ETH led will illuminate when you connect the
CopperJet to the Ethernetport on the PC or hub/switch.
USB: The USB led will illuminate when you connect the
CopperJet to the USB port on your PC, and the USB
drivers are installed. Note: not available on all units.
PWR: When the CopperJet is connected to a power source, the
PWR LED will illuminate.
2.2 CopperJet 81x back panel
LAN: To connect the CopperJet to the Ethernet port of the PC,
hub or switch.
USB: To connect the CopperJet to the USB port of the PC.
Note: not available on all units.
ADSL: To connect the CopperJet to the ADSL line of your
provider.
Power: Only the power adapter that comes with the package
can be connected to the power jack.