Installation manual

Chapter 5: Configuring the CopperJet
Page 32
5.5 DSL Line
The DSL Port menu allows you to configure specific DSL settings. Usually, the
default settings are sufficient to make a good DSL connection. Only for fine-
tuning or advanced administration, the DSL port menu brings useful information.
From the Configuration menu, go to Ports and click on DSL.
The DSL Port Configuration page is displayed.
This page provides the following information.
Connected: Shows if your DSL line is up (true) or not (false).
Operational Mode: The modulation type used to make the connection.
Advice: set the ADSLMode (line modulation) on
Multimode (Multimode.p for PSTN and Multimode.i for
ISDN).
State: Shows the status of the line: Handshake, Training or
Showtime.
Tx Bit Rate: The maximum Transmit Bit Rate of your DSL line.
Rx Bit Rate: The maximum Receive Bit Rate of your DSL line.
Annex Type: Shows which Annex Type you have: Annex A (PSTN)
or Annex B (ISDN).
After you changed the configuration, click on Apply. Don’t forget to save the
changes. Go to the Configuration menu and click on Save config to save the new
settings into the CopperJet.
Click on Reset if you want the previous settings.