Installation manual

Chapter 4: Before you start
Page 9
4 Before you start
The following information may be required for configuring the CopperJet. If you
do not know if all the information is needed, please contact your DSL service
provider before proceeding with the configuration.
4.1 IP Address Settings
The CopperJet allows the ISP to dynamically assign IP Address settings. If your
ISP requires static setting of specific IP address information, you need to receive
the following information:
IP Address
Subnet Mask
Default Gateway
4.2 Name Server Information
The CopperJet allows the ISP to dynamically assign Name Server Address
settings. If your ISP requires static setting of specific DNS address information,
you need to receive the following information:
Primary DNS Address
Secondary DNS Address
4.3 ATM Settings
The following ATM settings should be available during configuration
ATM Virtual Path ID (VPI); Required if not using default value
ATM Virtual Circuit ID (VCI); Required if not using default value
Encapsulation type; Required if not using default value
Modulation type; Required if not using default value
4.4 PPP Settings
The following PPP settings should be available during configuration of a PPP
connection.
Username (for PPP applications only)
Password (for PPP applications only).