Installation manual

Chapter 3: Connecting the CopperJet
Page 8
3 Connecting the CopperJet
To connect the CopperJet to the computer, you must have installed an Ethernet
10Base-T card in your computer. You need to have a static IP address on your
network card that is in the same subnet as the web interface IP address of the
CopperJet. The default web interface IP address for Ethernet is 172.19.3.1. For
USB, the default IP address is 172.20.3.1. When using the default IP addresses,
your network card can have the following IP address 172.19.3.2 with subnetmask
255.255.0.0
3.1 Connecting the CopperJet 81x
1. Connect the CopperJet with the Ethernet cross cable to your Computer.
2. Connect the RJ11 cable to your CopperJet, and into the phone outlet or
into the DSL splitter (if applicable).
3. Connect the power adapter in a power outlet and into the CopperJet.
3.2 Connecting the CopperJet 82x
1. Connect the CopperJet with the Ethernet straight cable to your Computer.
2. Connect the RJ11 cable to your CopperJet, and into the phone outlet or
into the DSL splitter (if applicable).
3. Connect the power adapter in a power outlet and into the CopperJet.