Installation Guide

Cap

Tumbler /Toothbrush

Holder

Backplate

Screw

0.7

Step 1:

Determine your desired location for installation and make a mark for the location . Make 2 marks where mounting screws will

be placed as shown below. Mark for location of installation.Drill hole at each end of the marks.

Drill holes in Wall for Backplate Mounting

Attach

Tumbler /Toothbrush Holder

to Backplate

Step 2:

Unscrew Cap.Then mount Backplate to desired location and screw them in placed.Then insert Tumbler/Toothbrush Holder

into Backplate and screw Cap.

426D

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

PAGE 1
426D INSTALLATION INSTRUCTIONS Step 1: Drill holes in Wall for Backplate Mounting 0.7 Determine your desired location for installation and make a mark for the location . Make 2 marks where mounting screws will be placed as shown below. Mark for location of installation.Drill hole at each end of the marks. Step 2: Attach Tumbler /Toothbrush Holder to Backplate Unscrew Cap.Then mount Backplate to desired location and screw them in placed.Then insert Tumbler/Toothbrush Holder into Backplate and screw Cap.