Service manual

800168 93
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
46. PRESSURE SWITCH
a. Unlock control panel. Refer to Figure 17, Step
1.
b. Pull top of control panel away from control
cabinet far enough to allow lifting control panel
up and off the rail support of the control
cabinet. Refer to Figure 17, Step 2.
c. Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 17, Step 3.
d. Remove two screws holding front of cabinet
top to top front edge of control cabinet front.
Refer to Figure 19.
e. If area or space permits, lift cabinet top to a
vertical position by hinging it on the rear
hinges.
NOTE: To avoid damage to hinges, be sure to
support cabinet top with a small chain or something
similar. Refer to Figure 21.
f. Disconnect wires from pressure switch at
disconnect block.
g. Disconnect pressure hose from pressure switch.
IMPORTANT: When installing pressure switch,
blow air into hose before connecting hose to switch
to remove any moisture that may have accumulated
in hose.
h. Squeeze in locking tabs on pressure switch and
push switch out toward rear of control shield.
Refer to Figure 24.
47. CONTROL CABINET FRONT
a. Unlock control panel. Refer to Figure 17, Step
1.
b. Pull top of control panel away from control
cabinet far enough to allow lifting control panel
up and off the rail support of the control
cabinet. Refer to Figure 17, Step 2.
c. Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 17, Step 3.
d. Remove two screws holding front of cabinet
top to top front edge of control cabinet front.
Refer to Figure 19.
e. If area or space permits, lift cabinet top to a
vertical position by hinging it on the rear
hinges.
NOTE: To avoid damage to hinges, be sure to
support cabinet top with a small chain or something
similar. Refer to Figure 21.
f. Remove screws holding security top panel to
control cabinet front. Refer to Figure 25. Slide
security top panel back just far enough to
disengage tabs on panel from control cabinet
front. Refer to Figure 25.
g. Remove two screws holding bottom front
flange of control cabinet front to top flange of
washer front panel. Refer to Figure 25.
h. Remove three screws (per side) holding control
cabinet front to front flange of control cabinet
wrapper. Refer to Figure 25.
i. Remove two screws holding control cabinet
wrapper tabs to control cabinet front tabs. Refer
to Figure 25.
j. Carefully pull control cabinet front straight out
and away from control cabinet wrapper. Refer
to Figure 25.