Service manual

90 800168
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
b. Installation:
(1) Lift coin drop up on coin drawer housing.
(2) Line up holes in the front face plate of coin
drop with the 2 guide wires. Slide coin
drop forward, making sure guide wires are
through holes in front face plate of coin
drop.
(3) Slide coin drop forward all the way until
front face plate of coin drop is up against
the control cabinet front, with the coin
return stop completely through slot.
(4) Using a 3/8 inch square drive 7/16 inch
socket with number 310P4 1/4 inch
Ratchet extension Tool, reinstall both
locknuts and tighten locknuts firmly.
(5) Reconnect coin drop wire harness.
(6) Reinstall security top panel and secure
using screws and carriage bolt previously
removed.
(7) Lower cabinet top into position and
reinstall 2 screws (previously removed)
holding cabinet top to top front edge of
control cabinet front. Refer to Figure 19.
(8) Reinstall control panel in control cabinet
and lock control panel.
44. CARD READER
a. Removal:
(1) Unlock control panel. Refer to Figure 17,
Step 1.
(2) Pull top of control panel away from control
cabinet far enough to allow lifting control
panel up and off the rail support of the
control cabinet front. Refer to Figure 17,
Step 2.
(3) Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 17, Step 3.
(4) Remove 2 screws holding front of cabinet
top to top front edge of control cabinet
front. Refer to Figure 19.
(5) If area or space permits, lift cabinet top to
a vertical position by hinging it on the rear
hinges.
NOTE: To avoid damage to hinges, be sure to
support cabinet top with a small chain or something
similar. Refer to Figure 21.
(6) Remove screws and carriage bolt holding
security top panel to control cabinet front.
Refer to Figure 21. Slide security top panel
back just far enough to disengage tabs on
panel from control cabinet front and
remove security panel. Refer to Figure 21.
(7) Disconnect card reader harness at
disconnect block.
(8) Use a 3/8 inch square drive socket, with
number 310P4 1/4 inch Ratchet Extension
Tool, to remove screws or nuts holding
card reader to control cabinet front and
carefully remove card reader out through
top of control cabinet. Refer to Figure 23.
NOTE: A 3/8 inch square drive socket, size 7/16
inch, fits over end of the 310P4 Extension Tool. A
1/4 inch ratchet fits in the other end. Refer to
Figure 23.
b. Installation:
(1) Carefully place card reader into opening in
control cabinet front.
(2) Using a 3/8 inch square drive 7/16 inch
socket with number 310P4 1/4 inch
Ratchet Extension Tool, secure card reader
to control cabinet front with screws or nuts
previously removed. Refer to Figure 23.
Then tighten screws or nuts firmly.
(3) Reconnect card reader harness.
(4) Reinstall security top panel and secure
using screws and carriage bolt previously
removed.
(5) Lower cabinet top into position nd reinstall
2 screws (previously removed) holding
cabinet top to top front edge of control
cabinet front. Refer to Figure 19.
(6) Reinstall control panel in control cabinet
and lock control panel.