Service manual

84 800168
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
39. INDICATOR LIGHT
(Door Locked)
a. Unlock control panel. Refer to Figure 17, Step
1.
b. Pull top of control panel away from control
cabinet far enough to allow lifting control panel
up and off the rail support of the control
cabinet. Refer to Figure 17, Step 2.
c. Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 17, Step 3.
d. While supporting control panel, disconnect
wires from indicator light.
NOTE: Refer to wiring diagram when rewiring
light.
e. Squeeze locking tabs together and pull light out
rear of control panel. Refer to Figure 18.
Figure 18
3
2
1
FLW1652S
LOCK
ASSEMBLY
SCREW
CONTROL
PANEL
OVERLAY
CONTROL PANEL
ASSEMBLY
INDICATOR
LIGHT
ELECTRONIC
CONTROL
CAM