Service manual

12 800168
Section 3 Troubleshooting
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
(5) Lift spring over left tab. Refer to Figure 5.
(6) Rotate spring clockwise, 40 to 60 degrees,
until it is free from right tabs. Refer to
Figure 6.
(7) Use screwdriver to remove spring from
center tab. Refer to Figure 6.
(8) Lift spring, with attached clip, off drop.
(9) Remove clip from spring. Refer to
Figure 7.
(10) Attach clip to new tension spring, Part No.
209/00598/02.
(11) Place clip, installed on spring, in slot on
coin drop. Refer to Figure 8.
(12) Use a small flathead screwdriver to push
spring under center tab. Refer to Figure 9.
(13) Lift spring gently to place in position under
left tab.
(14) Push spring to right until it snaps into
position. Refer to Figure 5.
(15) Close coin drop cover.
(16) Move tension spring over cover catch.
Refer to Figure 4.
REINSTALL COIN DROP INTO MACHINE
(1) Reinstall coin drop into machine.
(2) Reconnect electrical power to machine and
drop.
(3) Add a coin to drop to verify that coin drop
is operating properly and that electrical
connection is working properly.
Figure 6
Figure 7
Figure 8
MIX3B
Tabs
Center Tab
MIX4B
Clip
MIX8B
Slot
Figure 9
MIX5B
Small Flat
Screwdriver
Center
Tab
Left Tab