Service manual

800168 119
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 6
Adjustments
IMPORTANT: When reference is made to
directions (right or left) in this manual, it is from
operator’s position facing front of washer.
63. CABINET LEVELING LEGS
a. Place washer in position on a clean, firm and
reasonably level floor. Installing the washer on
any type of carpeting is not recommended.
b. Loosen locknuts and adjust the leveling legs
until the washer does not rock. Refer to
Figure 45.
NOTE: Level must rest on raised portion of top
panel. Refer to Figure 45.
c. Tighten the locknuts securely against the
washer base. If the locknuts are not tight,
washer will move out of position during
operation.
d. Remove rubber feet from accessories bag and
place on all four leveling legs. Refer to
Figure 45.
DO NOT slide washer across floor if the
leveling legs have been extended, as legs
and base could become damaged.
W248
CAUTION
Use of the dispenser drawer or washer door
as a handle in the transportation of the
washer may cause damage to the dispenser
or door.
W185
CAUTION
Figure 45
WASHER
BASE
LOCKNUT
LEVEL
SPACER
RUBBER
FOOT
LEVELING
LEG
(3/8 INCH)
H216SE3A
WASHER
BASE
LOCKNUT
LEVEL
RUBBER
FOOT
LEVELING
LEG
(1/2 INCH)
MODELS WITH THE LETTER “E” IN THE EIGHTH
CHARACTER OF THE MODEL NUMBER
MODELS WITH THE LETTER “H” OR “J” IN THE
EIGHTH CHARACTER OF THE MODEL NUMBER