Service manual

801681 89
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
42. MIXING VALVE
a. Front Control Washers –
(1) Unlock control panel. Refer to Figure 6,
Step “1”.
(2) Pull top of control panel away from control
cabinet far enough to allow lifting control
panel up and off the rail support of the
control cabinet front. Refer to Figure 6,
Step “2”.
(3) Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 6, Step “3”.
(4) Remove two screws holding front of
cabinet top to top front edge of control
cabinet front. Refer to Figure 13.
Figure 33
FLW1706S
Motor
Mounting
Bracket
Inner
Basket
Pulley
Pivot
Bolt
Adjusting
Bolt
Metal
Rod
Wire
Harness
1/4
Inch
Motor
Shaft
Belt
Adjusting
Bolt
Pivot
Bolt