Service manual

86 801681

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer before servicing.

• Never start the washer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer is properly grounded.

• Motor not grounded! Disconnect electric power before servicing motor.

W485

WARNING

40. GRAVITY DRAIN VALVE

a. While supporting the lower access panel,

remove two screws from bottom edge of lower

access panel. Refer to Figure 28.

b. Gently lower access panel to disengage panel

locators from bottom edge of front panel.

c. Loosen hose clamps and remove tub-to-drain

and drain-to-cabinet hoses connected to drain

valve. Refer to Figure 31.

d. Disconnect wires from drain valve.

NOTE: Refer to wiring diagram when rewiring

drain pump.

e. Remove screws holding valve to bracket and

remove valve through front of washer. Refer to

Figure 31.

Figure 31

FLW1685S

Tub-to-Drain

Hose

Bracket

Drain-to-Cabinet

Hose

Drain

Valve