Service manual

801681 85

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer before servicing.

• Never start the washer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer is properly grounded.

• Motor not grounded! Disconnect electric power before servicing motor.

W485

WARNING

39. ELECTRIC DRAIN PUMP

a. While supporting the lower access panel,

remove two screws from bottom edge of panel

and remove panel. Refer to Figure 28.

IMPORTANT: There will always be some water

that will remain in the pump and hoses. Therefore,

before removing hoses from pump, hoses must be

drained to prevent water spillage.

b. Loosen hose clamps and remove three hoses

connected to electric drain pump (outer tub-to-

pump hose, vent hose and drain hose). Refer to

Figure 30.

c. Disconnect wires from drain pump.

NOTE: Refer to wiring diagram when rewiring

drain pump.

d. Remove three mounting screws holding pump

to base and remove pump out through front of

washer. Refer to Figure 30.

Figure 30

FLW168

Outer

Tub-to-Pump

Hose

Mounting

Screws

Backflow

Preventer

Drain

Hose

Mounting

Screw

Electric

Drain Pump