Service manual

801681 71
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
Rear Control Washers
a. While supporting lower access panel, remove
two screws from bottom edge of panel and
remove panel. Refer to Figure 16.
b. Using the special tool, No. 318P4, remove
dispenser drawer. Refer to Figure 17.
c. Open loading door. Carefully remove wire
clamp ring from groove with small flat blade
screwdriver. Spring is in 6 o’clock position.
Refer to Figure 18.
d. Grasp loading door seal and slide seal away
from front panel around the circumference of
the door.
e. Remove bottom two front panel attaching
screws. Refer to Figure 20.
f. Remove front panel (with loading door
attached) away from washer as far as wires
permit.
g. Unplug wire harness from both the door latch
switch and from the door switch. Refer to
Figure 20. Remove clips holding wire harness
and door seal hose along top flange of front
panel and remove front panel.
Figure 16
H202SE1A
Screws
Lower
Access Panel
Panel
Locators
Figure 17
Figure 18
B
L
E
A
C
H
S
O
F
T
E
N
E
R
MAX
MAX
B
L
E
A
C
H
S
O
F
T
E
N
E
R
MAX
MAX
H125SE3B
Remove Drawer
From Housing
318P4
Dispenser Drawer
Tool
Insert
Tool
Pull Drawer Out
Slightly
H205SE1A
Screw
Wire
Clamp
Ring
Screw
Spring
Door
Seal