Service manual

62 801681
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
i. Indicator Lights (In Use, Rinse or Spin
Refer to Figure 8)
(1) Remove two control panel attaching
screws. Refer to Figure 7. Lay assembly
forward on protective pad on cabinet top.
(2) Disconnect wires from light.
NOTE: Refer to wiring diagram when rewiring
light.
(3) Squeeze locking tabs together and pull light
out rear of control panel.
Electronic Control Models
IMPORTANT: Due to the sensitivity of the
electronic control, careful handling is required. As a
precautionary measure, we recommend using a
ground wrist strap when handling the electronic
control. Wrist strap, cord and alligator clip are
designed to carry away any electrostatic charge
from your body and to direct charge to an available
ground. By using this static protection device,
potential electrostatic discharge problems
associated with handling of electronic control will
be minimized. Always handle electronic control by
its metal edges. If a wrist strap is not available,
touch washer while it is plugged in before handling
control to dissipate any charge.
a. Remove two control panel attaching screws.
Refer to Figure 7. Lay assembly forward on
protective pad on cabinet top.
b. Disconnect all wires and harness connectors
from electronic control and indicator light.
NOTE: DO NOT pull on wires. Instead, hold board
near appropriate disconnect block and unplug by
pulling on disconnect block.
c. Remove ground clip holding ground wire to
control panel.
NOTE: Refer to wiring diagram when reconnecting
wires.
Figure 9
W492SE1B
Lockwashers
Panel
Screw
Wash
Temperature
Switch
Motor
Speed
Switch
Setscrew
Knurled
Nut
Knob