Service manual

60 801681
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the washer before servicing.
Never start the washer with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
28. CONTROL PANEL (Rear Control Washers)
Electromechanical Models
a. Remove two control panel attaching screws
holding control panel to control hood. Refer to
Figure 7. Lay assembly forward on protective
padding on cabinet top.
b. While supporting control panel, disconnect all
wires from control panel components. DO NOT
pull on wires.
NOTE: Refer to wiring diagram when reconnecting
wires.
c. Loosen setscrews holding switch knobs to
temperature and motor switch shafts and pull
knobs off switch shafts. Refer to Figure 8.
d. Remove nuts holding temperature and motor
switches to control panel and remove switches.
Refer to Figure 8.
e. Remove nut holding push-to-start switch to
control panel and remove switch. Refer to
Figure 8.
f. Squeeze locking tabs together holding indicator
light(s) to control panel and pull light out rear
of control panel. Refer to Figure 8.
g. Remove ground clip holding ground wire to
control panel.
h. Motor Speed Switch or Wash Temperature
Switch:
(1) Remove two control panel attaching
screws. Refer to Figure 7. Lay assembly
forward on protective pad on cabinet top.
(2) Loosen setscrew holding switch knob to
switch shaft. Refer to Figure 9.
(3) Remove knurled nut holding switch to
control panel. Refer to Figure 9.
NOTE: Lockwasher must be between switch and
control panel when installing switch. Refer to
Figure 9.
(4) Disconnect wires from switch.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
Figure 7
H199SE1A
Control
Panel
Control Panel
Attaching
Screws
Protective
Padding