Service manual

116 801681
Section 6 Adjustments
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
58. CLEANING COIN DROP
a. Disconnect electrical power to machine and
drop.
b. Remove coin drop from machine. Refer to
Paragraph 34.
c. If lint is preventing coins from rolling through
coin drop, blow compressed air though coin
entry and along the side of the coin drop. Refer
to Figure 49.
d. Insert a coin through the coin drop. If coin does
not roll through drop, continue with the
following.
e. Remove cotter pin from top of drop. Refer to
Figure 49. Save pin for reinstallation when
cleaning is complete.
f. Move metal clip closer to sensor so that it
comes off frame. Refer to Figure 49.
g. Remove coin return from coin drop frame.
Refer to Figure 50.
h. Check coin path in coin drop for lint and
residue. If lint or light residues are present, use
a cotton swab to remove. If heavy residue is
present, it may be necessary to first scrape off
excessive residue and then use a cotton swab
dipped in water or isopropyl alcohol (rubbing
alcohol) to remove remainder of residue. Refer
to Figure 51.
Figure 49
DRY3B
Compressed
Air
Cotter
Pin
Metal
Clip
Figure 50
Figure 51
DRY4B
Coin Drop
Frame
Coin
Return
DRY5B
Cotton
Swab