Service manual

801681 111
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
Section 6
Adjustments
IMPORTANT: When reference is made to
directions (right or left) in this manual, it is from
operator’s position facing front of washer.
53. CABINET LEVELING LEGS
a. Place washer in position on a clean, firm and
reasonably level floor. Installing the washer on
any type of carpeting is not recommended.
b. Loosen locknuts and adjust the leveling legs
until the washer does not rock. Refer to
Figure 44.
NOTE: Level must rest on raised portion of top
panel. Refer to Figure 44.
c. Tighten the locknuts securely against the
washer base. If the locknuts are not tight,
washer will move out of position during
operation.
d. Place rubber feet on all four leveling legs. Refer
to Figure 44.
DO NOT slide washer across floor if the
leveling legs have been extended, as legs
and base could become damaged.
W248
CAUTION
Use of the dispenser drawer or washer door
as a handle in the transportation of the
washer may cause damage to the dispenser
or door.
W185
CAUTION
Figure 44
FLW1965N
H360I
FRONT CONTROL WASHERS
REAR CONTROL WASHERS
Leveling
Leg
Leveling
Leg
Level
Washer
Base
Locknut
Rubber
Foot
Level
Washer
Base
Locknut
Rubber
Foot