Service manual

803402 17
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 4
Electronic Control Troubleshooting
7. Error Code Listing
Following is a list of possible error codes for an
electronic control. Errors beginning with “EI” refer to
external device Infra-red communication errors. Errors
beginning with “EC” refer to card reader errors. All
other errors refer to machine errors.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
Display Description
Cause/
Corrective Action
EI01
Transmission Failure Communication failure. Re-aim external device and try
again.
EI02
Time-out Error Communication failure. Re-aim external device and try
again.
EI03
Invalid Command Code Communication successful, but the command was not
valid for this machine type, or the control could not
perform the command in its current mode of operation.
Ensure data is for current machine type and control is in
correct mode.
EI04
Expecting Upload Request Communication failure. Re-aim external device and try
again.
EI05
Invalid or Out-of-Range Data The value in at least one of the programming options is
invalid or out of range. Recheck the programming
option’s value and try again.
EI09
CRC-16 Error Communication failure. Re-aim external device and try
again.
EI0A
Framing Error Communication error. Re-aim external device and try
again.
EI0C
Time-out Exceeded Communication error. Re-aim external device and try
again.
EI0E
Encryption Error Communication error. Re-aim external device and try
again. If the problem persists, check that the security
code is correct.
Table 3