Service manual

803402 13

General Troubleshooting

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer before servicing.

• Never start the washer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer is properly grounded.

• Motor not grounded! Disconnect electric power before servicing motor.

W485

WARNING

(12) Use a small flathead screwdriver to push

spring under center tab. Refer to Figure 9.

(13) Lift spring gently to place in position under

left tab.

(14) Push spring to right until it snaps into

position. Refer to Figure 5.

(15) Close coin drop cover.

(16) Move tension spring over cover catch.

Refer to Figure 4.

Reinstall Coin Drop Into Machine

(1) Reinstall coin drop into machine.

(2) Reconnect electrical power to machine and

drop.

(3) Add a coin to drop to verify that coin drop

is operating properly and that electrical

connection is working properly.

Figure 9

MIX5B

Small Flat

Screwdriver

Center

Tab

Left Tab