Datasheet
Table Of Contents
- DDR3L SDRAM
- Description
- State Diagram
- Functional Description
- Functional Block Diagrams
- Ball Assignments and Descriptions
- Package Dimensions
- Electrical Specifications
- Thermal Characteristics
- Electrical Specifications – I DD Specifications and Conditions
- Electrical Characteristics – 1.35V IDD Specifications
- Electrical Specifications – DC and AC
- ODT Characteristics
- Output Driver Impedance
- Output Characteristics and Operating Conditions
- Speed Bin Tables
- Electrical Characteristics and AC Operating Conditions
- Electrical Characteristics and AC Operating Conditions
- Command and Address Setup, Hold, and Derating
- Data Setup, Hold, and Derating
- Commands – Truth Tables
- Commands
- Input Clock Frequency Change
- Write Leveling
- Initialization
- Voltage Initialization / Change
- Mode Registers
- Mode Register 0 (MR0)
- Mode Register 1 (MR1)
- Mode Register 2 (MR2)
- Mode Register 3 (MR3)
- MODE REGISTER SET (MRS) Command
- ZQ CALIBRATION Operation
- ACTIVATE Operation
- READ Operation
- WRITE Operation
- PRECHARGE Operation
- SELF REFRESH Operation
- Extended Temperature Usage
- Power-Down Mode
- RESET Operation
- On-Die Termination (ODT)
- Dynamic ODT
- Synchronous ODT Mode
- Asynchronous ODT Mode
- Asynchronous to Synchronous ODT Mode Transition (Power-Down Exit)

Figure 37: Tangent Line for
t
DH (DQ – Strobe)
V
SS
Hold slew rate
falling signal
ΔTFΔTR
=
V
DDQ
V
IH(AC)min
V
IH(DC)min
V
REF(DC)
V
IL(DC)max
V
IL(AC)max
Tangent
line
DC to V
REF
region
Hold slew rate
rising signal
=
DQS
DQS#
CK#
CK
DC to V
REF
region
Tangent
line
Nominal
line
Nominal
line
Tangent line (V
IH(DC)min
- V
REF(DC)
)
ΔTF
Tangent line (V
REF(DC)
- V
IL(DC)max
)
ΔTR
t
DS
t
DH
t
DS
t
DH
Note:
1. The clock and the strobe are drawn on different time scales.
8Gb: x4, x8, x16 DDR3L SDRAM
Data Setup, Hold, and Derating
107
Rev 2.0 June 2016
© 2015 Alliance Memory, Inc. All rights reserved.
Alliance Memory Inc. reserves the right to change products or specification without notice
Alliance Memory Inc. 511 Taylor Way, San Carlos, CA 94070
TEL: (650) 610-6800 FAX: (650) 620-9211