Datasheet

8.5.2 Output Slew Rate Characteristics
PARAMETER MIN MAX UNIT NOTES
Pull-up and Pull-Down Slew Rate for Full Strength Driver 0.7 2.5 V/ns 1,2
Pull-up and Pull-Down Slew Rate for Three-Quarter Strength Driver 0.5 1.75 V/ns 1,2
Pull-up and Pull-Down Slew Rate for Half Strength Driver 0.3 1.0 V/ns 1,2
Output Slew rate Matching ratio (Pull-up to Pull-down) 0.7 1.4 - 3
Notes:
1. Measured with a test load of 20 pF connected to V
SSQ.
2. Output slew rate for rising edge is measured between VILD(DC) to VIHD(AC) and for falling edge between VIHD(DC) to VILD(AC).
3. The ratio of pull-up slew rate to pull-down slew rate is specified for the same temperature and voltage, over the entire temperature and
voltage range. For a given output, it represents the maximum difference between pull-up and pull-down drivers due to process variation.
8.5.3 AC Overshoot/Undershoot Specification
PARAMETER SPECIFICATION
Maximum peak amplitude allowed for overshoot 0.5 V
Maximum peak amplitude allowed for undershoot 0.5 V
The area between overshoot signal and VDD must be less than or equal to 3 V-ns
The area between undershoot signal and GND must be less than or equal to 3 V-ns
AS4C32M16MD1A-5BCN
Confidential
- 50/56 -
Rev.1.2 July 2016