Specifications

Maintenance
F232086
36
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Weekly
1. Check the washer-extractor for leaks.
a. Start an unloaded cycle to fill the washer-
extractor.
b. Verify that door and door gasket do not leak.
c. Verify that the drain valve is operating and
that the drain system is free from obstruction.
If water does not leak out during the prewash
segment, drain valve is closed and functioning
properly.
Monthly
NOTE: Disconnect power to the washer-extractor
at its source before performing the monthly
maintenance procedures.
1. Each month OR after every 200 hours of
operation, lubricate bearings of the UW60.
(Locate the bearing lubrication decal. See
Figure 19.)
Figure 19
PHM675N
1 Bearing Lubrication Decal
PHM675N
1