Specifications

Installation

F232086

Figure 16

Table 9

Connecting External Liquid Supplies

to the Washer-Extractor

1. Remove plugs from base. See Figure 16. Plugs

are assembled inside the tubing ring.

2. Install strain reliefs, included in the seal nut.

3. Insert tubes through base. Do not remove cups.

Tube should extend into the plastic cup, with the

exception of the softener tube, which should be

routed to the outside of the cup.

4. Tighten the seal nut to prevent tubing from

escaping the assembly.

The UW 3-speed washer-extractor has a

polypropylene supply dispenser with five supply

compartments. See Figure 17.

Do not attempt to make chemical injection electrical

connections to points other than those provided

specifically for that purpose by the factory.

PHM673N

1 Tubing from Pump

2 Seal Nut

3 Tubing Ring

4 Base

5 Lid

6 Nut

Chemical Injection Supply System

Number of dry supply compartments 5

Number of liquid supply connections 5

Liquid supply connection size, in (mm) 5/8 (15.9)

PHM673N