Specifications

Installation

F232086

Steam Requirements

(Steam Heat Option Only)

For washer-extractors equipped with optional steam

heat, install piping in accordance with approved

commercial steam practices. Steam requirements are

shown in the table below.

The optional steam connection for above models is

located at the upper right corner of the rear panel, as

seen from the rear.

Table 8

NOTE: Failure to install the supplied steam filter

may void the warranty.

Steam Supply Information

Steam inlet connection, in (mm) 1/2 [DN13] (12.7)

Number of steam inlets 1

Recommended pressure, psi (bar) 30 – 80 (2.0 – 5.4)

Maximum pressure, psi (bar) 80 (5.4)

Never touch internal or external steam

pipes, connections, or components.

These surfaces can be extremely hot and

will cause severe burns. The steam must

be turned off and the pipe, connections,

and components allowed to cool before

the pipe can be touched.

SW014

WARNING