Specifications

ManualsBrandsAlliance Laundry Systems ManualsDomestic AppliancesUW35S3

Installation

F232086

Refer to Table 3 for capacity-specific drain

information.

Installation of additional washer-extractors will

require proportionately larger drain connections. Refer

to Table 4.

Tabl e 3

Table 4

Water Connection

Table 5

Connections should be supplied by hot and cold water

lines of at least the sizes shown in the Water Supply

Line Sizing table. Installation of additional machines

will require proportionately larger water lines. See

table.

To connect water service to machine with rubber

hoses, use the following procedure:

1. Before installing hoses, flush the water system

for at least two minutes.

2. Check filters in the washer-extractor’s inlet hoses

for proper fit and cleanliness before connecting.

3. Hang the hoses in a large loop; do not allow them

to kink.

If additional hose lengths are needed, use flexible

hoses with screen filters. Each hose should have a

screen filter installed to keep rust and other foreign

particles out of the water inlet valves.

Pressure of 30 – 85 psi (2 – 5.7 bar) provides best

performance. Although the washer-extractor will

function properly at lower pressures, increased fill

times will occur.

Drain Information

35 60

Drain connection size, I.D.,

in (mm)

2-3/8 (60) 3 (76)

Number of drain outlets 1 1

Drain flow capacity, gal/min

(l/min)

35 (132) 64 (242)

Recommended drain pit size,

(l)

5 (142) 6 (170)

Drain Line Sizing

Minimum Drain I.D. in (mm)

Number of

Machines

35 60

1 3 (76.2) 3 (76.2)

2 3 (76.2) 4 (102)

3 3-1/2 (89) 6 (152)

4 4 (102) 6 (152)

Water Supply Information

Water inlet connection size, in (mm) 3/4 (19)

Number of water inlets (standard) 4

Recommended pressure psi (bar) 30 – 85 (2 – 5.7)

Inlet flow capacity, gal/min

(l/min) (80 psi)

35 28 (106)

60 39 (148)