Installation manual

Diagnostic

F8138801

Factory Valve Purge Menu

The Factory Valve Purge Menu is used to allow the

factory to purge all the valves inside the machine after

the machine has been manufactured and tested.

Press the keypad to activate the step. The step

will run for five (5) minutes unless the keypad is

pressed.

Test Balance Weight Menu

The Test Balance Weight Menu is used to check and

display the current machine balance type and its status.

The machine must be equipped with a variable

frequency motor drive. The display shows balance

types and corresponding switch states: CLOSED, 1

Hz, 2 Hz, 3 Hz, or OPEN. The keypad initiates

the test. Press the or keypad to end the

test. A UNLOCK key press command will be

recognized while the test is not in operation. Press

the or keypad again and the display to

return to the Test Menu.

PHM1057R

Figure 60

Factory Valve Purge

Press START

to Begin

FACTORY VALVE PURGE

PHM1058R

Figure 61

Test Balance Weight

Press START

to Begin

TEST BALANCE WEIGHT

Balance Type #2

PASS