Specifications

ManualsBrandsAlliance Laundry Systems ManualsComputer equipmentUniLinc

Maintenance

Routine maintenance maximizes operating efficiency and mini-

mizes downtime. The maintenance procedures described below

will prolong the life of the machine and help prevent accidents.

WARNING

Sharp edges can cause personal injury. Wear safety

glasses and gloves, use proper tools and provide

lighting when handling sheet metal parts.

W366R1

CAUTION

Replace all panels that are removed to perform serv-

ice and maintenance procedures. Do not operate the

machine with missing guards or with broken or

missing parts. Do not bypass any safety devices.

SW019

Follow local codes for proper advise on laundering infected gar-

ments.

On UniLinc Control models, maintenance checklists are also dis-

played on the control. Press

to enter Service Schedule Menu.

Refer to Figure 41 .

Monthly

Service Schedule Menu

PHM707N_SVG

Quarterly

WeeklyDaily

Figure 41

Press from Cycle Menu to enter Service Menu. The Service

Menu provides a user with a time based service reminder list. The

list is broken up into “DAILY”, “WEEKLY”, “MONTHLY” and

“QUARTERLY”.

The following maintenance procedures must be performed regu-

larly at the required intervals.

Daily

WARNING

Do not spray the machine with water. Short circuit-

ing and serious damage may result.

W782

IMPORTANT: Door lock should be checked daily to en-

sure proper operation. Also check that all safety and

instruction stickers are on the machine. Any missing or

illegible safety instructions stickers should be replaced

immediately.

Beginning of Day

1. Check door interlock before starting operation:

a. Attempt to start the machine with the door open. The ma-

chine should not start.

b. Close the door without locking it and start the machine.

The machine should not start.

c. Attempt to open the door while the cycle is in progress.

The door should not open.

If the door lock and interlock are not functioning properly, dis-

connect power and call a service technician.

IMPORTANT: Door lock should be checked daily to

ensure proper operation. Also, check that all safety

and instruction stickers are on the machine. Re-

place as necessary.

2. Inspect water inlet valve hose connections on the back of the

machine for leaks.

3. Inspect steam hose connections for leaks (where applicable).

4. Inspect all chemical inlets, lines and connections for leaks.

WARNING

To reduce the risk of electrical shock, serious in-

jury or death, disconnect the electrical power to

washer-extractor before examining the wiring.

W636

5. Verify that insulation is intact on all external wires and that

all connections are secure. If bare wire is evident, call a serv-

ice technician.

End of Day

1. Clean the inverter drive filter (where applicable):

Maintenance

F8410701ENR10