Specifications

ManualsBrandsAlliance Laundry Systems ManualsComputer equipmentUniLinc

Cycle

Number Cycle Name

1 Permanent Press Light Soil

2 Light Soil

3 Permanent Press Medium Soil

4 Medium Soil

5 Permanent Press Heavy Soil

6 Heavy Soil

7 Rags

8 Reclaim

9 Delicates

10 90°C

11 60°C

12 40°C

13 90°C Permanent Press

14 60°C Permanent Press

15 40°C Permanent Press

16 70°C Permanent Press

17 50°C Gentle

18 30°C Gentle

19 Custom #1

20 Custom #2

21 Custom #3

22 Custom #4

23 Custom #5

24 Custom #6

25 Custom #7

26 Custom #8

27 Custom #9

28 Custom #10

29 Custom #11

30 Custom #12

Table 34

CAUTION

Water cannot be extracted from rubber backed

items. To avoid damage to machine from out of bal-

ance conditions, do not use a spin (extract) step

when washing rubber backed items. Warranty will be

voided.

W880

7. Press the START keypad to start the selected cycle.

As the cycle proceeds, the display will show and count down the

remaining cycle time.

To begin the cycle at any step other than the first step, press the

START keypad to advance through the cycle to the desired start-

ing point. Refer to the Programming Manual for information to

disable Rapid Advance.

If the door is open, the display will indicate that the door needs to

be closed and locked.

8. Close the door to start a cycle.

The cycle will continue until its completion. Then the display

will show the door is ready to be unlocked and opened.

NOTE: Since the machine MUST drain and balance

before it can extract, the control will only Rapid Ad-

vance to a drain step that occurs before an extract

or spray rinse extract step.

9. Emergency stop button (refer to Figure 37 ) should be de-

pressed to terminate machine operation when any unsafe con-

dition is present during machine operation.

a. Press red emergency stop button to stop all action.

b. To restart machine, pull red emergency stop button out

and press START keypad.

NOTE: Activation of the emergency stop button

stops all machine control circuit functions, but

DOES NOT remove all electrical power from ma-

chine.

Shakeout Routine

WARNING

NEVER insert hands or objects into basket until it

has completely stopped. Doing so could result in se-

rious injury.

SW012

A shakeout agitation step is programmed at the end of every cy-

cle and will help prevent tangling of the load.

The shakeout time is set at the factory to agitate for 32 seconds.

Operation

F8410701ENR10