Specifications
Steam Requirements (Steam Heat Op-
tion Only)
WARNING
Hot Surfaces. Will cause severe burns. Turn steam
off and allow steam pipes, connections and compo-
nents to cool before touching.
W505
For machines equipped with optional steam heat, install piping in
accordance with approved commercial steam practices. Steam re-
quirements are shown in Table 32 .
Steam Supply Information
Capacities 45-105 130-160
Steam inlet connec-
tion, in. [mm]
1/2 [DN13] 3/4 [DN13]
Number of steam
inlets
1 1
Recommended
pressure, psi [bar]
30 – 85 [2.0 – 5.9] 30 - 85 [2.0 - 5.9]
Maximum pressure,
psi [bar]
85 [5.9] 85 [5.9]
Table 32
IMPORTANT: Failure to install the customer supplied
steam filter may void the warranty.
Chemical Injection Supply System
WARNING
Dangerous Chemicals. May damage eyes and skin.
Wear eye and hand protection when handling chemi-
cals; always avoid direct contact with raw chemicals.
Read the manufacturer’s directions for accidental
contact before handling chemicals. Ensure an eye-
rinse facility and an emergency shower are within
easy reach. Check at regular intervals for chemical
leaks.
W363
IMPORTANT: Undiluted chemical dripping can damage
the machine. Therefore, all chemical injector supply
dispenser pumps and dispenser tubing should be
mounted below the machine’s injection point. Loops
do not prevent drips if these instructions are not fol-
lowed. Figure 22 shows a typical Chemical Injection
Supply System. Figure 24 shows a typical Five Com-
partment Supply System.
IMPORTANT: Failure to follow these instructions could
damage the machine and void the warranty.
A connection has been placed at the back of the machine. There
are six ports in this connection, through each of which a liquid
supply hose can be connected, and one water flush port.
Outer ports must be drilled through with a 3/16 inch diameter
drill bit and center port must be drilled through with a 1/2 inch
diameter drill bit before connecting chemical lines. Refer to Fig-
ure 21 .
CAUTION
Drill out plugs and nipples before making supply
hose connection. Failure to do so can cause buildup
of pressure and risk a tubing rupture.
W491
Specifications and Dimensions
F8410701ENR10
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 53