Specifications

ing proper reinforcing bar supports to hold bars at the proper

depth in the pad.

10. Allow adhesive around reinforcing bar to cure properly, refer

to adhesive manufacturer for recommended cure times.

11. Completely fill with 3500 psi concrete up to the existing

foundation level plus any added level (maximum of 8 inch

[203 mm]) for the desired elevated pad. The concrete must be

poured so that the entire foundation and pad cures as one

piece.

12. Allow concrete to cure, refer to manufacturer’s recommended

cure times.

13. Using a mounting bolt template or machine base, mark where

the holes should be drilled to mount the machine.

NOTE: As an alternate method, cast in the Grade 5

(minimum SAE rating), .75 inch [19 mm] anchor

bolts as the concrete is poured, refer to Figure 14 .

Ensure that the bolt threads extend a minimum of

2.75 inches [70 mm] above floor level and a mini-

mum of 6 inches [152 mm] of the bolt is embedded

in concrete.

14. Proceed to Machine Mounting and Grouting section.

Specifications and Dimensions