Specifications

Installation

202629ENR3

1. Remove the Phillips head screw from service

door (refer to Figure 23).

2. Remove two screws holding control panel to

control hood.

3. Tilt control panel forward and lay on a protective

pad to prevent scratching of cabinet top.

4. Insert Phillips head screw down through double

“D” hole in left rear corner of cabinet top (inside

control hood) until it engages retainer nut located

on left rear corner gusset of cabinet.

5. Finger tighten screw.

IMPORTANT: Do not use a power driver to tighten

screw. Torque of a power driver could over-tighten

screw causing damage to cabinet assembly.

6. Secure control panel to control hood using two

No. 8 tamper-resistant screws, Part No. 35528.

7. Remove two screws holding front panel to base

of washer and install two No. 12 tamper-resistant

screws, Part No. 35527.

Figure 23

To reduce the risk of electric shock, fire,

explosion, serious injury or death:

• Disconnect electric power to the washer

before servicing.

• Never start the washer with any guards/

panels removed.

• Whenever ground wires are removed

during servicing, these ground wires

must be reconnected to ensure that the

washer is properly grounded.

W003

WARNING

Any disassembly requiring the use of tools

must be performed by a suitably qualified

service person.

W299

TLW2102N

1 35528 No. 8 Screws

2 Double “D” Hole

3 35527 No. 12 Screws