Specifications

ManualsBrandsAlliance Laundry Systems ManualsDomestic AppliancesSWF

Installation

803148

Grounding Instructions

The washer must be grounded. In the event of

malfunction or breakdown, grounding will reduce the

risk of electric shock by providing a path of least

resistance for electric current.

The washer is equipped with a cord having an

equipment-grounding conductor and a three-prong

grounding plug. The plug must be plugged into an

appropriate outlet that is properly installed and

grounded in accordance with all local codes and

ordinances.

DO NOT modify the plug provided with the washer –

if it will not fit the outlet, have a proper outlet installed

by a qualified electrician.

NOTE: Have a qualified electrician check the

polarity of the wall receptacle. If a voltage reading

is measured other than that in Figure 11, the

qualified electrician should correct the problem.

Step 8: Check Installation

Refer to Installer Checklist on the back cover of this

manual and make sure that washer is installed

correctly.

Run washer through one complete cycle to make sure

it is operating properly.

Vending

Meter Case

The factory mounted coin meter case does not include

the service door lock, coin drawer, coin drawer lock or

keys. These parts must be ordered (at extra cost)

according to the purchaser’s requirements direct from

the manufacturer of your choice.

NOTE: You have the option of using a screw type

lock or a 1/4 turn lock on the meter case service

door. If you choose to use a screw lock, then the

special bracket (located inside the meter case) must

be used. DO NOT use the special bracket if a 1/4

turn lock is used.

Coin Drawer Security – For additional security, drill

out the two pilot holes on each side of the front of the

meter case to 1/4 or 5/16 inch (6.4 or 7.9 mm) holes

and install a bicycle lock through these holes.

NOTE: An 8 in. (20.32 cm) coin drawer is required.

Models Prepped for Card Reader

The machine is shipped from the factory with the

Electronic Control Diagnostic Harness Assembly

unplugged. To avoid unauthorized manual

programming or vending, perform the following steps.

1. Open control panel. Refer to Figure 12.

2. Locate diagnostic harness on electronic control.

3. Plug connectors for “white/black” wire and “red/

blue” wire together.

Figure 12

Improper connection of the equipment-

grounding conductor can result in a risk

of electric shock. Check with a qualified

electrician or service person if you are in

doubt as to whether the washer is

properly grounded.

W327

WARNING

FLW6R

1 Control Panel