User Manual and Operating Guide

Installation

802702

4. Use the three screws from the accessories bag to

attach the power cord wires to the terminal block.

Refer to Figure 13.

Figure 13

5. Tighten all screws firmly.

IMPORTANT: Failure to tighten these screws

firmly may result in wire failure at the terminal

block.

6. Secure the strain relief to the power cord, or

wires, where they enter the dryer cabinet.

7. Check the continuity of the ground connection

before plugging the cord into an outlet. Use an

acceptable indicating device connected to the

center grounding pin of the plug and the green

screw on the back of the cabinet.

8. Reinstall access cover and screw.

Connecting Power Cord with Four-Wire Plug

NOTE: Four-wire cord is required for new branch-

circuit installations, mobile homes or where codes

do not permit grounding through neutral.

Figure 14

1. Disconnect power to dryer.

2. Remove access cover from rear of dryer.

Figure 15

D286I

1 “L1” Terminal

2 Neutral Terminal

3 “L2” Terminal

DRY2016N

1 Typical Four-Wire Receptacle

2 Power Cord – Not Supplied with Dryer

3 Strain Relief Nut

4 Strain Relief

D695I

120 ± 12

V.A.C.

120 ± 12

V.A.C.

120 ± 12

V.A.C.

120 ± 12

V.A.C.

240 ± 12

V.A.C.