User Manual and Operating Guide

Installation

802702

Step 3: (Non-Gravity Drain Models Only)

Connect Drain Hose to Drain Receptacle

Remove the drain hose from its shipping position on

the rear of the washer by removing the shipping tape.

IMPORTANT: Drain receptacle must be capable of

handling a minimum of 1 3/8 inch (3.5 cm) outside

diameter drain hose.

Standpipe Installation

Place the drain hose into the standpipe.

Remove the beaded strap from accessories bag and

place around standpipe and drain hose and tighten

strap to hold hose to standpipe. Refer to Figure 5. This

will prevent the drain hose from dislodging from drain

receptacle during use.

Step 4: (Gravity Drain Models Only)

Connect Drain Outlet to Drain System

Remove drain fitting (four inches long) and hose

clamp from accessories bag. Insert drain fitting into

drain outlet hose. Clamp hose and fitting.

Connect the drain fitting to a vented drain system

using a flexible connection (obtain locally). Inside

diameter of fitting is 1.53 in. (3.89 cm) and outside

diameter is 1.66 in. (4.22 cm). The drain system must

be vented to prevent an air lock or siphoning.

IMPORTANT: Increasing the drain hose length,

installing elbows, or causing bends will decrease

drain flow rates and increase drain times,

impairing machine performance.

Figure 6

SWD835N

1 Drain Hose

2 Beaded Tie-Down Strap

3 Standpipe 2 in. (5.08 cm) or 1-1/2 in. (4 cm)

Figure 5

24 in. to 36 in.

(61 to 91.44 cm)

Recommended

Height

SWD745N

1 Drain Trough

2 Drain Outlet Hose

SWD745N