User Guide

Installation

801539

Location Requirements

Select a location with a solid, sturdy and level floor.

DO NOT install unit on carpeting, soft tile, pedestal, a

platform or other weakly supported structures.

The unit must not be installed or stored in an area

where it will be exposed to water and/or weather.

All four legs must rest firmly on the floor so the

weight of the unit is evenly distributed. The unit must

not rock and must be level from side-to-side and front-

to-back.

IMPORTANT: Unless completely assembled, DO

NOT slide the unit across the floor. DO NOT slide

the unit more than four feet once the leveling legs

have been extended, as the legs and the base could

become damaged.

The unit needs sufficient clearance and an adequate air

supply for proper operation and ventilation, and for

easier installation and servicing. (Minimum clearances

are shown in Figure 34.)

Figure 34

NOTE: Shaded areas indicate adjacent structure.

SWD748N

A B

Dryer and Exhaust Duct Clearances

Area Description Minimum Clearance

A Left Dryer Side 0 in. (0 cm)

B Right Dryer Side 1 in. (2.54 cm)

C Dryer Top 6 in. (15.24 cm)

D Dryer Rear 4 in. (10.2 cm)

E Exhaust Duct Clearance to Combustible Materials 2 in. (5.1 cm)